OWIM SOKL 1920 B2 Montage-, Bedienungs- Und Sicherheitshinweise Seite 14

3. Connecting the cables (Fig. G)
Plug the camera connection cable
connection port on the PoE adaptor cable
14
.
15
Connect the plug of the power adaptor
the connection for the power adaptor
Plug the power adaptor
appropriate indoor power supply .
NOTE: The red LED
product is connected to the power supply .
4. Router (Fig. G)
NOTE: Before you can use the camera
wirelessly, it must be set up through a cable
connection .
Preparation:
–Check if your router (not included) has an
active internet connection .
–Connect your smart device with the router .
–Read your router's instruction manual, if
needed .
Connect the Ethernet cable (not included) to a
free slot on the router .
Connect the other end of the Ethernet cable
into the connection port
adaptor cable .
15
NOTE: The green LED
product is connected to the router .
NOTE: The camera needs about 1 minute of
a startup time after it is powered on . The product
is ready for setup when the green LED
continuously .
5. Configuring a new camera
Download and install the "Silvercrest IP Cam
S-K 1920" application on your smart device .
The application is available in the App Store
for iOS devices and in the Google Play
store for Android devices .
Alternatively scan the appropriate QR code
for your smart device operating system:
14 GB
into its
5
to
18
.
17
into an
18
indicates that the
3
16 of the PoE
indicates that the
4
flashes
4
®
TM
Open the application on your smart device
and tap icon to add the camera .
NOTE: Follow the installation steps of the
app during Wi-Fi setup .
Select "Outdoor Camera" .
Tap "Configure a new Camera" .
Tap "Next" .
Tap "Next" . The application searches for the
camera by its identification code (DID) .
NOTE: The DID code is located under the
QR code sticker on the main unit (near to the
rating plate) .
Once the camera has been found, assign a
name to the camera and set a new admin
password .
NOTE: For your own privacy and safety, you
are required to setup a secure 12-digit password
consisting of uppercase and lowercase letters,
numbers, and special characters . Keep the
password well for future need .
The setup process brings you to the Wi-Fi
connection setup .
The Wi-Fi router default password is usually
labelled at the back of the router . If you have
changed the default password to a custom
one, make sure the password is correct before
you start the Wi-Fi setup of the camera .