Motostar LIVIPR Bedienungsanleitung Seite 5

Programming an intercommunicating group
y
Programming an intercommunicating group must be carried out AFTER assigning the call key to all of the
receivers.
PROG
1
SW3
M2
M2
PROG
M2
2
SW3
3 beep
M2
3
PROG
4
SW3
M2
M2
1
M2
2
M2
Assigning intercommunicating groups
PROG
With the SW3 jumper inserted, press the PROG key for at least 8 seconds
>8''
<11''
and release it (within 11 seconds) 1 as soon as the PROG LED flashes and
the key back lighting comes on 2.
SW3
To enable the intercom function, go to the receiver that you want to pro-
gramme, and press the intercom call key you want to call from: a beep
will sound to show that programming has taken place 3. Repeat for all
receivers to be included in the intercommunicating group.
At the end, briefly press the PROG key 4.
PROG
NOTE: If no action is performed, the procedure will end automatically
after 30 minutes.
SW3
y
Once a receiver has been included in an intercommunicating group
by assigning the intercom call button, it cannot be excluded from this
group. If you want to change the intercom call button on a receiver
PROG
which has already been programmed as an intercommunicating receiv-
<1''
er, or you want to add new receivers to the group, repeat the operations
detailed under "Programming an intercommunicating group".
SW3
PROG
Deactivating intercommunicating groups
To deactivate the intercom function, you simply have to disconnect the
SW3
SW3 jumper 1; by doing this, programming of the intercom system is
also inhibited.
PROG
To reactivate this function you must restore factory settings.
SW3