Motostar LIVIPR Bedienungsanleitung Seite 4

Reprogramming
PROG
M2
M2
SW3
1
2
BOUT
beep
4
PROG
M2
M2
SW3
E
PROG
M2
M2
SW3
F
G
BOUT
M1
8
BOUT
Going into Programming
PROG
>3''
Press the PROG key for at least 3 seconds 1 and then release it (within 6
<6''
seconds) as soon as the PROG LED flashes and the key back lighting lights
up as illustrated in figure 2.
SW3
PROG
3
M2
Continue, repeating the same operations for all the other receivers.
PROG
<1''
Exiting Programming
Press the PROG button briefly E. The PROG LED switches off.
SW3
NOTE: If no action is performed, the procedure will end automatically
after 30 minutes.
Programming Type of Keys
In "Programming Call Keys", press the PROG key for at least 3 seconds
PROG
>3''
F and then release it (within 6 seconds) as soon as the PROG LED lights
<6''
up and the key back lighting flashes as illustrated in figure G, entering
"Programming Type of Keys".
SW3
Press the first key on the entry panel in the position shown 8 until the
back lighting LEDs stop flashing I and stay on.
At the end, to exit programming, briefly press the PROG key E: the PROG
LED switches off.
If no action is performed, the procedure will end automatically after 30
minutes.
PROG
M2
M1
9
BOUT
M2
Programming call keys
Press the door release
the same time.
On the entry panel, press the call key to be linked to
the receiver 4: a beep will confirm that the setting has
been stored.
M2
and AUX2 buttons C at