diversey TASKI swingo XP-M IntelliSweep Bedienungsanleitung Seite 51

Cleaning start
• If the machine is switched on and the
operator is standing on the running
board, the machine starts moving as
soon as the driving switches are op-
erated. If selected, the brush unit and
lateral cleaning brushes are started
and the cleaning solution supply is
opened.
The speed is controlled by the posi
tion of the driving switch. When the
driving switch is released, the ma
chine is automatically decelerated
until it stops and the parking brake is
activated. The cleaning solvent sup
ply is closed, and the brush unit and
lateral cleaning brushes are stopped
with some delay.
Notice:
The supply volume of the cleaning solution
is adjusted to the corresponding working
speed. (IntelliFlow)
Attention:
When working in heavily furnished or nar-
row zones, the slow approach ON/OFF
button must be pressed. (Display lights up)
The maximum working speed is reduced,
and thus so is the risk of accidents.
• Pressing this button once more will override
this restriction, and the display disappears.
• If the red display on the battery level indica-
tor lights up, you must drive the scrubber
dryer to the battery charger.
Battery capacity - end of operational readiness
The battery level indicator provides information on the avail-
able operating time.
• If the red indicator begins to flash, approx. 5 minutes of
residual working time are left.
• After this period, the brush unit and – 30 seconds later –
the squeegee is lifted. The red display switches to continu-
ous light.
• Now 10 more minutes remain for driving the machine to the
charging station. Then the machine is automatically
switched off.
• In order to restart, the batteries must be fully charged.
Cleaning method
Direct working method:
Scrubbing, dry cleaning, wet cleaning and suction in one work
step.
Indirect working method:
Applying the cleaning solution, scrubbing, dry cleaning and
suction in several work steps.
Notice:
The machine guiding might be impaired in
case of special combinations of flooring/
contamination and cleaning product.
Optionally available wheels can improve
the traction of the machine on the floor.
Please contact your TASKI customer con-
sultant.
-
Replenishing cleaning solvent
-
Attention:
The flooring may be damaged when work-
-
ing without cleaning solution.
Notice:
A rattling noise from the pump indicates an
empty fresh water tank (Flextank).
Attention:
The pump must never run dry for an ex-
tended period.
• The machine must be switched off.
• Open the tank lid.
• Fill water into the fresh water tank (Flextank), see page 46.
• Add the cleaning product using the dosing cup.
• Tip the tank cover back into its original position and press
it down until it locks.
Draining dirty water
Recovery tank full display:
• If the Recovery tank display lights up, the
cleaning program is interrupted, the squee-
gee is lifted and the suction unit is switched
off.
• Drain the recovery tank, see page 50.
Notice:
In case of frothing in the tank, the recovery
tank display also lights up.
• Drain the recovery tank, see page 50.
EN
49