Perel Tools PAG12501 Bedienungsanleitung

PAG12501/PAG125012 – ANGLE GRINDER 900W
1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised company for
recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities
Thank you for buying a PEREL TOOLS 125mm/900W angle grinder! Unpack the device. You will see you have
acquired a powerful and versatile device. Please check carefully that there is no damage caused by transportation.
Should there be any, consult your dealer and don't use this device.
2. General Safety Instructions
Keep this device away from
rain and moisture.
Do not expose charger and battery
to temperatures above 50°C.
Recycle the battery in an
environmentally safe way.
Wear protective goggles.
• Make sure to respect all national safety regulations concerning installation, operation and maintenance.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer will
not accept responsibility for any ensuing defects or problems.
• Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached the ambient temperature.
• This device falls under protection class II.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
• Never let the power cable get in front of the device while it is being used!
• All modifications of the device are forbidden for safety reasons. Damage caused by such modifications is not
covered by the warranty. Never overload the machine!
.
Disconnect from mains before starting
maintenance operation.
Do not incinerate batteries.
Wear a mask in dusty conditions.
Always wear protective gloves.
Do not operate this device
while the housing is open.
Do not expose charger
or battery to water
Wear ear-muffs. Loss of hearing can be
a gradual process.
Always wear a helmet.