Telcoma Automations ZEN 100E Bedienungsanleitung Seite 55

GB
Fig. 11 Fig. 12
GEARMOTOR INSTALLATION: insert the gearmotor in the rear end section of the guide until the drive shaft H
is completely inserted. Facilitate this operation by turning the gearmotor. Then secure the gearmotor by means
of the M8x30 screws (fig. 13). Proceed with the electrical system set-up. In the case of particularly small-sized
garages, and if lighting needs to be improved, the ZEN gearmotor can be rotated through 180°(the opposite of fig.
13), thus positioning the courtesy light towards the exterior.
Fig. 13
Z124 ELECTRONIC CONTROL UNIT
The automations ZEN 100 and ZEN 60 are equipped on board with a control board model Z124, from which all
electrical connections are made (motor, encoder, power supply, etc.) with a connector for a radio receiver mod.
OC (optional) and a screw terminal for the courtesy light.
55