Assembly - SoFlow Flowboard Air Originalbetriebsanleitung

3.3 Assembly

Please check the contents according to point 1 "Introduction" to assembly your Flowboard Air as follows:
1. Unpack your Flowboard Air.
2. Take the two handlebars out of the protective cover.
3. Unfold the device following the instructions in point 3.2 "Folding and unfolding".
4. Open the screws on the upper section of the steering head where it is connected with the handle bar (see figure 1).
5. Now you can mount the two handles. Turning clockwise will tighten the handles, turning anti-clockwise will loosen
them (see figure 2).
6. Tighten the screws again firmly.
7. You can now turn on the device using the central push-button on the display.
Figure 1
copyright by www.so-flow.com
Figure 2
15
Flowpad Bedienungsanleitung
User Manual