Citizen Systems CT-S651 Type II Benutzerhandbuch Seite 59

Switch no.
MSW10-4 Old Command
MSW10-5 Buzzer Event
MSW10-6 Buzzer Sound
MSW13-1 Security/Target
MSW13-5 BT Device Scan
MSW13-6 Auto Reconnect
*1: If print data is very dense, the print head is hot, data transmission is slow, or some other conditions, the
motor and printing may occasionally stop which causes white stripes in the printout. To print high-
density data, set MSW2-3 (Spool Print) to ON to reduce striping, although this increases the time before
printing starts.
For a serial interface, increase the transmission speed to prevent the motor from stopping.
*2: The values for memory switches MSW7-X are only effective when DIP switch no. 1 is set to OFF .
Function Initial setting
Invalid
Not by
C.Open
Tone 2
Low/All
Discoverable No Response, Discoverable
Valid
Invalid, CBM1, CBM2
All Event/Error, Not by C.Open, Not by C.Open/PE
Tone 1, Tone 2, Tone 3, Tone 4
Low/All, Mid/All, Mid/Paired only, Hi/All, Hi/Paired
only
Invalid, Valid
— 55 —
Setting value