Tektronix TDS3ION Handbuch Seite 6

General Safety Summary
Safety Compliance
4
Australia / New Zealand Declaration of Conformity – EMC. Complies with the
EMC provision of the Radiocommunications Act per the following standard, in
accordance with ACMA:
CISPR 11:2003. Radiated and Conducted Emissions, Group 1, Class A, in
accordance with EN 61326- 1:2006.
EC Declaration of Conformity – Low Voltage. Compliance was demonstrated
to the following specification as listed in the Official Journal of the European
Communities: Low Voltage Directive 2006/95/EC.
EN 61010-1: 2001. Safety requirements for electrical equipment for
measurement control and laboratory use.
U.S. Nationally Recognized Testing Laboratory Listing.
UL60950-1, Safety for Information Technology Equipment.
Canadian Certification.
CAN/CSA C22.2 No. 60950-1, Safety for Information Technology
Equipment.
Additional Compliances.
IEC 61010-1: 2001. Safety requirements for electrical equipment for
measurement, control, and laboratory use.
Equipment Type. Test and measuring equipment.
Safety Class. Class 1 – grounded product.
Pollution Degree Description. A measure of the contaminants that could occur in
the environment around and within a product. Typically the internal environment
inside a product is considered to be the same as the external. Products should be
used only in the environment for which they are rated.
Pollution Degree 1. No pollution or only dry, nonconductive pollution occurs.
Products in this category are generally encapsulated, hermetically sealed, or
located in clean rooms.
Pollution Degree 2. Normally only dry, nonconductive pollution occurs.
Occasionally a temporary conductivity that is caused by condensation must
be expected. This location is a typical office/home environment. Temporary
condensation occurs only when the product is out of service.
Pollution Degree 3. Conductive pollution, or dry, nonconductive pollution
that becomes conductive due to condensation. These are sheltered locations
TDS3ION Battery Charger Instructions