Front View - SCOPREGA Bravo 20 Bedienungsanleitung

Suggested Uses:
• Large Rigid inflatable like SUPs / Inflatable Boats, Kayak, Kites etc.,
• Lazarettes for Super Yachts
• Rafts, air mattresses, swimming pool floats, etc.
Characteristics:
• Capacity
• Max Pressure
• Pressure setting
• Modes
• Safety Fuse
• Battery Charging port
• External Battery Port
• Inflation fittings
• Carry bag dimensions
1. On - Off switches
2. Pressure regulation Gauge with Diagnostic Lights
3. Outlet (inflate) Port
4. Air hose with adaptors
5. Inlet (deflate) Port
6. 110-240 V Adaptor
7. 12 Vdc Cable with Alligator Clips
8. 12 Vdc Vehicle Cable Plug
Meaning of the Gauge Light:
1. Green RUN and Battery OK
2. Yellow Battery LOW
3. Red Over-temperature. The Unit stops
4. Red Battery TOO LOW. Press OFF
125 L/min
1500 mbar (22 psi)
Gauge with auto shut off
INFLATE and DEFLATE
30 Amps
(Jack Type)
Cable with alligator clips
available for most common valves
220x320x220 mm
FEATURES
5 1
7

FRONT VIEW

Port for External Battery Plug for Recharge adaptor
HOSE AND CORD STORAGE
• The 12 Vdc cords and the air hose are located in the carry bag
• The accessories like 110 – 240 Vac Battery Charger and cigarette
Plug are stored on the lower compartment of the carry bag.
FITTING THE ACCESSORIES
• Your inflator is supplied with the standard tapered nozzles that are located inside the
lower compartment of the carry bag.
• Make sure that the Unit is
• Remove the hose from the storage location
• Press the air hose clips to the port to inflate (OUT) or deflate (IN)
• Fit the air hose adaptor to the inflatable
OPERATING THE INFLATOR
• To INFLATE Connect the tube to the outlet port. Set the Pressure Knob to the desired limit.
2 3 4
• Press the ON
• The inflator will stop automatically when the inflatable reaches the set value
8
• To DEFLATE Connect the tube to the inlet port. Set the Pressure Knob to
• Press the ON
• THE INFLATOR WILL NOT STOP AUTOMATICALLY. PRESS THE OFF PUSH BUTTON TO STOP
• If the light on the Gauge
a Vehicle Plug or to an external battery via cable and alligator clips.
• If the light on the Gauge turns
external battery via cable and alligator clips.
WARNING: Make sure polarity is correct (Red to Positive).
6
With wrong polarity the Inflator WILL NOT START
• Press the ON
WARNING: Exercise with care when connecting the cord to batteries in order not to short
the battery with conducting materials such as rings, bracelets and keys.
The battery or conductor may overheat and cause burns.
WARNING: Check the proper Power Voltage.
Do not operate a 12Vdc inflator with a 24 V power supply
USE of BRAVO 20
OFF (no light on the Gauge)
Push button; the unit will Start and the light on the Gauge will turn
Push button; the unit will Start and the light on the Gauge will turn
turns YELLOW press OFF and connect the inflator to
RED press OFF and connect the inflator to an
Push button; the unit will Start and the light on the Gauge will turn
GREEN
0,5
GREEN
GREEN