Switching On; Temperature Control; Speed Control - Barloworld Scientific Techne HB-1D Bedienungsanleitung

H B - 1 D O P E R A T O R ' S M A N U A L

Switching On

Once your HB-1D is connected to a power supply, switch it on using the power switch next
to the power inlet socket on the rear panel.

Temperature Control

Power indicator
Heater indicator
Over
Temperature
Indicator
When you first switch on, the display will show the edition of the software which
your unit uses. For example software issue "1" would be shown as follows:
It will display this for 1 second, then the actual temperature of the incubator will
be indicated.

Speed control

14
Temperature display
Front panel of the HB-1D
Temperature
Set button
Controller Display
Fully anticlockwise the speed control knob switches the rotation of the
tubes off
It then increases the speed clockwise and decreases the speed
anticlockwise in steps of approximately 4 rpm. Switch the knob until you
have the speed you require.
Speed control knob
Increase
button
Decrease
button