Troubleshooting - Inventum IKV1782S Gebrauchsanleitung

Warning: Never remove the ice with the aid of sharp objects, defrost sprays, a hair-drier, a heater, or similar items. This
may lead to unsafe situations and may cause irreparable damage to the appliance.
• Clean the interior of the appliance. Use warm water and a neutral detergent to prevent any bad smells occurring. After
cleaning, rinse the interior with clean water and rub dry.
• Leave the appliance to dry for 1 to 2 hours. Simply remove the drawers, the glass shelves and the door compartments to
clean them by hand. Do not clean the interior accessories in the dishwasher.
• Clean the outside of the appliance and the gasket with a soft moist cloth.
• Switch the thermostat on to the right setting. When the refrigerator reaches its correct temperature, replace the food
items.
NOTES
• Excessive accumulation of ice on the freezing areas impairs the appliance's freezing capacity and increases the energy
consumption.
• Defrost the appliance at least once or twice a year. In case of a higher ice build-up, defrosting must be carried out more
frequently.
• After taking the food out of the appliance, put it in a container, wrap it with several layers of paper, a blanket and store it at
a cool place.
• The defrosting operation should last as short as possible. Long storage of food at the ambient temperature shortens
their shelf life.
REPLACING THE LED LIGHTING
This appliance is equipped with LED lighting. It can be used for a long time. In case, if the LED lighting is blown, it must be
replaced by a qualified person to avoid any hazard. Contact the Inventum service department.
7

troubleshooting

If your freezer does not work properly, this can be caused by a minor problem. First check the following items before
contacting an electrician. This will save you time and money.
Problem
Appliance does not do
anything
Temperature in the
freezer is too high or
too low
Appliance makes noise
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
Cause
- Plug not in socket
- Power interruption
- Thermostat is set to [OFF]
Incorrect thermostat setting
Ventilation holes are blocked
Is the appliance properly installed?
Does the rear of the appliance make
contact with something?
Solution
- Insert the plug in the socket
- Check the fuse box
- Set the thermostat to setting 1 to 7
Set the thermostat to the correct setting
Clean the ventilation holes
Check the installation - is the appliance level?
Check this and move the appliance forward
29
English •