Infant Child Restraint Installation; Installing Without Base - Joie Gemm Bedienungsanleitung

!
The shoulder harnesses must be placed in back of the
two iron tubes.
!
During adjustment, make sure the shoulder harnesses
are not twisted.
!
Use extreme care in threading the shoulder harnesses
according to the figure. If the shoulder harnesses are not
secure, they will not protect your baby properly.
Securing Child
Restraint
Note
1. Insert is for infant's protection. Infant weighing under
10kg must use the insert
2. Before using the insert
3. After child is placed into the seat, check whether the
shoulder harnesses are at proper height.
1. While pressing the harness adjustment button, pull completely
the two shoulder harnesses of the infant child
2. Unlock the buckle of the harnesses by pressing the red
button. (Fig.15)
3. There are 2 positions crotch harness adjusted according to
different requirements.
Position 1 Smaller babies use this position
Position 2 Larger babies use this position
i. Pull the crotch harness out and place it to be level.
(Fig.17.1&Fig. 17.2&Fig. 17.3)
ii. Rotate the crotch harness anchor to make the short side
forwards, then thread it through the crotch harness slot.
(Fig.17.4)
23
in the Infant Child
.
A or B
A , please assemble foam. (Fig. 13)
restraint.(Fig. 14)
(Fig.16.1)
(Fig.16.2)
iii. Rethread it through the slot that is closest to child's
crotch from the front of the crotch harness.
4. Place child into the infant child restraint and lock the buckle.
(Fig. 18 & 19)
5. Tighten the shoulder harnesses by pulling adjustment
webbing. (Fig. 20)
!
Make sure the space between the child and the shoulder
harnesses is about the thickness of one hand.
Infant Child Restraint
Installation
The installation instructions vary depending on whether or not
you are using the base. Please refer to the proper section.
!
Do not place the infant child restraint on front vehicle seat
with airbag. Death or serious injury can occur.
!
When using the infant child restraint in a vehicle seat,
please adjust the handle to position 1.
!
Face your child restraint or base toward the rear of the vehicle.
!
Ensure the vehicle safety belt is not loose or twisted.
i. Installing without Base
After fitting the harness to your child and determining which
rear vehicle seat location is best, you are ready to install your
infant child restraint.
1. Place the infant child restraint onto the vehicle seat where
you wish to put it. Pull the vehicle safety belt out and lock it
into the vehicle buckle, sliding the vehicle lap belt into the
side guides of the infant child restraint.
(Fig. 16)
(Fig. 21)
(Fig. 5.1)
(Fig. 22)
24