Herunterladen Inhalt Inhalt Diese Seite drucken

Aeroplane Lnstallation; Handle Adjustment; Shoulder Harness Position; Shoulder Harness Strap Height Adjustment - Joie Gemm Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Gemm:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 25
!
DO NOT install this infant child restraint on unstable vehicle
seats during installation.
!
To know more detailed installation information for seat with
base, please refer to the section 'Vehicle Fitting Information'.

Aeroplane lnstallation

!
The gemm can only be installed using a lap belt if being
used in an aircraft without the base. Do not install in a
vehicle using a lap belt.
!
When being used in an aircraft, the infant child restraint
must only be installed rear facing on the seat.
!
Gemm child restraint width is 435mm, but some aircraft
seat widths are 430mm. For narrow seat, please place
padding under the seat to raise the height and allow it to fit
between the arm rests.

Handle Adjustment

The handle of the infant child restraint can be adjusted to 3
positions.
(Fig. 5)
Position 1 Position for car, hand or stroller transportation.
Position 2 Rocking position.
Position 3 Baby chair position.
To adjust the handle, squeeze handle buttons on both sides to
release it
(Fig.
6.1), and then rotate the handle until it clicks into
any of the 3 positions.
(Fig. 6.2)
21

Shoulder Harness Position

Check that shoulder harnesses are set at the proper height.
Please choose the proper pair of shoulder harness slots
according to the child's height.
!
Shoulder harnesses must go into the harness slots nearest
to your baby's shoulders
shoulder line.
!
If the shoulder harnesses are not at proper height, the child
might be thrown from the infant child restraint when there is
an accident.
(Fig. 47)
Shoulder Harness Strap Height
Adjustment
1. Press the adjustment button at the front of the seat and pull
the shoulder harnesses to loosen them.
2. At the back of the seat, take the harness ends off the metal
junction plate.
3. Pull the harnesses through the slots in the seat
insert them into the appropriate set of slots.
a.Thread the shoulder strap through shoulder harnesses.
b.Thread the shoulder harness anchor through the shoulder
harness slot.
c.Thread the shoulder strap through the shoulder harness slot.
4. Reassemble the harness ends onto the junction plate.
!
Thread the shoulder strap through the shoulder harness
anchor.(Fig. 12.1)
(Fig.
7), but not above the
(Fig. 8)
(Fig. 9)
(Fig. 10)
(Fig.
11.1),
(Fig. 11.2)
(Fig. 12)
22

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Gemm

Inhaltsverzeichnis