Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
(not on EV222)
1. Select SET-UP and press SET.
2. Select DATA and press SET.
3. Select DURATION and press SET.
4. Select the desired time for the data-logging and press SET.
5. Select LOG and press SET.
6. Decide whether or not all data (voltage, current, power, time) during
the next experiments should be logged and press SET.
7. Select SET-UP and press SET to return.
•
Starting a new experiment will erase the previous data in memory.
•
Stored data can be transferred to a computer via the RS232 output using free avail-
able software (www.consort.be).
At any time, you can return in the stand-by mode by holding SET pressed during 2
•
seconds.
GROUND LEAKAGE
SHORT-CIRCUIT
OVERLOAD
CURRENT<1mA
CALL SERVICE
•
You could also try a general RESET: switch the instrument on while holding SET
pressed. Attention! All stored programs and data will be erased!
EV202 • EV222 • EV215 • EV231 • EV232 • EV233 • EV243 • EV261 • EV262 • EV265
EV202 • EV222 • EV215 • EV231 • EV232 • EV233 • EV243 • EV261 • EV262 • EV265
= A dangerous ground leakage is present (check
thoroughly the complete assembly). Your power
supply is NOT defective! See Frequently Asked
Questions at the end of this manual.
= Connected tank is short-circuited or has a very
low resistance (check thoroughly the complete
assembly). Your power supply is NOT defective!
See Frequently Asked Questions at the end of
this manual.
= Connected tank has a too low resistance (check
specifications). Your power supply is NOT
defective! See Frequently Asked Questions at
the end of this manual.
= The output current is lower than 1 mA (switch
the alarm off in the SET-UP menu). Your power
supply is NOT defective! See Frequently Asked
Questions at the end of this manual.
= Failure in the electronics. See Support on
www.consort.be.
----
----
-----
SET
SET pressed during 2
LOG DATA
FOR:
-----
LOG
DATA:
-----
***
***
***
***
***
Data-logging
Data-logging
STAND-BY
SET-UP
SET-UP
DATA
DATA
-----
DURATION
DATA
-----
LOG
DATA
-----
SET-UP
ERROR
GROUND LEAKAGE
ERROR
SHORT-CIRCUIT
ERROR
OVERLOAD
ERROR
CURRENT<1mA
ERROR
CALL SERVICE
----
----
10h
YES
Alarms
***
***
***
***
***
6 6
Werbung
Inhaltsverzeichnis
