oscartielle URANO Betriebsanleitung Seite 18

Warning: It is allowed to stick advertising material on the unit, only if the sheets are thin. It is forbidden to screw thick and
insulating materials on the outer sides of the cabinet.
S FORBIDDEN TO DRILL THE INTERNAL AND EXTERNAL WALLS OF THE CABINET IN ANY WAY (e.g to
Warning: IT I
in stall a superstructure), as the evaporator and condenser tubes running inside the cabinet walls could be damaged.
Warning: Do not expose the unit
the unit with wet or damp hands or feet.
Warning: Do not remove protective guards or covers that requ
circumstance, the cover from the switchboard.
Warning: Do not overload the unit, do not get
shelves for objects.
Warning: Do not use the cabinet with
Warning: Do not attem pt to remove any formation of ice using sharp metal objects.
Warning: The re frigeration system does not cause any chemical alterations to the nature of the water produced by the
defrosting cycle. This water co
water produced by the system must be removed
with the laws in force.
Warning: Any use of the unit
the manufacturer c annot be held responsible for any damage that may be caused owing to an improper, incorrect or
unreasonable use of the unit.
Warning: Do not damage the refrigerant circuit (IEC60335-2-89:2002 and
Warning: Do not use electrical appliances inside the food storage compartments
type recommended by the manufacturer (IEC60335-2-89:2002 and changes)
Warning: This appliance is not intended for
capabilities, or lack of experience and knowledge, unless they
the appliance by a person responsible for their safety.
Warning: Children should be supervised to ensure tha
9 – Defrosting of the unit and evaporation of the con
The model Urano is equipped with an electronic thermostat.
The formation of ice inside the cabinet depends mainly on ambient conditions (a
s liding doors or left open for a long time). It is advisable to defrost the unit following the instruction listed below, when the
thickness of the frost layer exceeds approx. 10 mm or at leas
should be defrosted even twice in a month.
Warning: Do not attempt to remove any formation of ice or frost using sharp metal objects.
- Move the products into another cabinet or in a coldroom
- Unplug the unit
- Slide the lids over each other or remove them
- Leave unit to defrost until the walls are f
- Wipe the condensation water with a sponge or a rag
- Dry and clean the interior cabinet
- Close the sliding covers and fit the plug into the socket. Push the on/off button if necessary. Reach the internal
temperature as written in point 7 before introducing the products back into the cabinet.
Version with hot gas automatic defrost
The defrost takes place each 72 hours. The value is set in the factory and it can be modified if the environmental conditions
are very different from those of the project. The defrost is by hot gas. T
tray placed into the motor compartment. The evaporation of the water takes place by mean of the coil of the drain pipe of the
compressor.
Warning: Any adjustments
Warning: Do not use electrical appliances inside the food storage compartments of the appliance, unle
type recommended by the manufacturer (IEC60335-2-89
10 – Cl
eaning the unit
Warnin g: Before cleaning the unit, always cut off the electric power supply.
Clean the unit periodically using neutral detergents and dry it using soft cloth. Do not use inflammable or abrasive products
and do not clean the unit with direct jets of water. When cleaning the inside of the unit, wear protective g
skin from being into direct contact with the cold parts. Clean the glass covers with a commercially available window cleaner.
Warning: The top covers are made in low-emissivity glass. Its frame is treated with a lubricating oil. To kee
sliding freely, the frames should be cleaned regularly to remove dust and dirty.
Warning: Turn the unit on again only when it has been ascertained that all the parts are dry (those that have been
a nd those that have not). Reload the unit following the instructions given in Para. 7.
11 – Unit maintenance
Warning: All the operations described in this paragraph must be performed by qua
Warning: Before proceeding with the maintenance operations, cut off the electric power supply.
16
to atmospheric agents, do not use direct jets of water to clean the unit, do not touch or use
inside the island, do not step onto the sliding covers and do not use them as
out sliding covers and do not leave them open.
mes only from the vapour contained in the air circulating inside the system. However, the
via the drainage system or using water conditioning systems that comply
, not in according to the prescriptions given in this manual, has to be considered dangerous and
use by persons (including children) with reduced physical, sensory or mental
ree of any lays of frost or ice
or alterations must be realised by technical assistance staff only.
ire tools for their removal, do not remove, under any
changes)
have been given supervision or instruction concerning use of
t they do not play with the appliance.
densation water
t once a month. In particularly wet times of the year, the unit
he condensation water flows through a drain into a
:2002 and changes).
of the appliance, unless they are of the
ir humidity) and use (frequent opening of the
lified staff.
ss they are of the
loves to prevent the
p the covers
removed