Weelko F336A Bedienungsanleitung Seite 9

MICRO-CRYSTAL DERMABRASION
Instructions of use
1. Assembly the plastic handle holder in on side of the
device.
2. Properly plug the pipes as shown in the sketch
below. Plug them in the device socket and in the
containers, it's enough by introducing it and do gentle
pressure. To withdraw the pipes, press the round
plastic part in the plug and pull the pipe without
forcing.
3. Fill with micro-crystal the container #2 without
exceeding the line. The cap thread must be completely
clean of micro-crystal. Is recommended to use #120
particle size micro-crystal.
Important note: is prohibited manipulate micro-crystal
with hands.
4. Select the desire power output and time of working
by pressing "ENERGY" and "TIMER" respectively.
"ENERGY" can be adjusted between 1 and 10. "TIMER"
can be adjusted between 1 and 60 minutes.
5. Press "START/PAUSE" button to start. The handle
showed in the display will the machine is working
normally. The operation can be paused and restart by
pressing this button.
6. Once the operation time has finished, the device will
emit a "beep" and the selected function will stop. The
device is now in standby mode.
7. Once the treatment has finished, the used
micro-crystal have been deposited in the container #1.
The container #2 is empty. Remove and discard the
used micro-crystal. Fill the container #2 for future
treatments. The cap thread must be completely clean
of micro-crystal.
Important note: is prohibited manipulate micro-crystal
A B
with hands.
Notes
•
During the treatment, always keep the handle under
the device level. Do not work with the handle over the
device level.
•
The direct contact to the skin is 3–5 seconds only.
After this time, lift the handle and apply it to another
part of the treatment area.
Cautions
•
Clean and dry skin. No need to apply lotion for
treatment.
•
During the operation on the eyes, please adjust the
air pressure about 1-5 , and it will be enough after
gently hand over twice.
•
Avoid sun exposure for 24 hours after treatment.
•
Do not use makeup for 4 hours after treatment.
•
Do not make sauna sessions during the 10 days after
treatment.
•
After treatment, use neutral products to moisturize
the skin rather than acidic.