Windows Nt - Bitronics AutoSwitch Set Benutzerhandbuch

P73121/F1U126-KIT/EU/man.qxd
Change printer port from LPT1 to AutoSwitch port

(Windows NT

®
The Printer properties in Windows NT
the software and restarting the computer, go the printer properties and
select the PORTS tab. To find the correct ports to be used with the
Bitronics switch, you must scroll down the list until the LPT1: PB
(autoswitch) comes up. Put a checkmark on the port that connects to the
printer. In this case, it is Port B on the Bitronics switch:
4/28/00 1:06 PM
Windows NT
only):
15
Page 15
®
® is slightly different. After installing
En