Software Installation - Bitronics AutoSwitch Set Benutzerhandbuch

P73121/F1U126-KIT/EU/man.qxd
There are two driver disks included with the package. Make sure you put in
the correct disk in your computer depending on your operating system.
When the setup program asks you what model switch you have, make sure
you select F1U126.
• For Windows
then click RUN. In the space, enter "a:\BITRONIX.exe". The setup
program will commence. Follow the on-screen instructions.
• For MS-DOS (disk P72735), enter the following at the command prompt:
copy a:\DOS\swport.com c:\
• For Windows
space, enter "a:\Setup.exe". The setup program will commence. Follow
the on-screen instructions.
For proper operation, make sure that:
• The Bitronics software is loaded on both computers. Note that it is not
necessary that both computers be of the same operating system. Just
make sure that the correct Bitronics software is installed based on the
operating system.
• The software and drivers of the device to be shared (i.e. printer,
scanner, etc...) is also loaded on both computers. This is necessary for
each computer to access and use the shared device properly.
Usage – 4 PCs to 1 device mode
When you have four PCs sharing one device (such as a printer, scanner or Zip
Drive), you do not need to use the software. The AutoSwitch automatically
scans all four computers waiting for a print job or requests access to the
shared device. When a computer needs access, the AutoSwitch automatically
connects the device to that computer. After the computer is done accessing
the device, then the AutoSwitch returns to its normal polling mode.
Sharing one scanner, one Zip
the Bitronics AutoSwitch. And since it is automatic, operating systems such
as Windows ® 95 and higher will automatically detect devices through the
AutoSwitch such as a Zip
the computer.
You will see the LEDs flashing back and forth on all the ports on the Bitronics
AutoSwitch. When it locks onto a port, the LED on that port remains lit.
4/28/00 1:06 PM

Software Installation

® 95/98 and Windows NT
® 3.x (disk P72736), click on FILE, then click RUN. In the
® Drive, or one printer is easy and seamless with
® Drive, as if it was connected directly to
6
Page 6
® (disk P72735), click on START,
®