RAIS VISIO 1 Bedienungsanleitung Seite 205

Rebuilding to self-closing door after, the oven has been built in.
The door is made self-closing by dismantling some of the door's counterweights. On the VISIO 1
& 3, the counterweights must be changed on both sides.
1. Remove the Side Skamol sheet.
2. Remove the access panel.
Access panel.
3. Unscrew the retaining ring (Allen key 2.5mm). Remove
the required number of counterweights, so that the door
closes slowly and at a constant speed. Check its operation.
Retaining ring.
Counterweights.
4. Tighten the retaining ring (Allen key 2.5mm).
Retaining ring.
5. Refit the access panel and side Skamol sheet.
Access panel.
69