Detaching The Plasma Display From The Stand; Specifications; Dimensions Diagram; Caution - Pioneer PDK-TS05 Bedienungsanleitung

Detaching the Plasma Display from the Stand

To remove the plasma display from the stand, be sure
to always follow the procedure described below to
prevent accidents

Caution

1
First, confirm that the forward/backward
inclination anchor bolt is securely
tightened.
2
First clear a space on a flat floor etc. where
you can lay the plasma display flat, then
lay a sheet to protect it from scratches or
other damage.
3
Remove the speakers.

Specifications

External dimensions
Weight
• The above specifications and exterior may be modified without prior notice to improve the product.

Dimensions Diagram

Unit: mm (inch)
The illustration measurements do not include the fixtures for attaching the speakers.
When installing the PDP-S25-LR or the PDP-S26-LR speakers
1500 (59-1/16) [50 inch display model: when doing air installation] *
1462 (57-9/16) [50 inch display model: when doing flush installation] *
1350 (53-3/16) [43 inch display model: when doing air installation] *
1312 (51-11/16) [43 inch display model: when doing flush installation] *
• When using the support columns L, the height is 910 (35-7/8) [50 inch display model] / 825 (32-1/2) [43 inch display model].
* 1 Air installation: Attached to allow adjustment of the speaker angle
* 2 Flush installation: Attached to fix the speaker angle and give the system a more compact width
22
En
577 (W) x 351 (H) x 380 (D) mm (22-3/4 (W) x 13-7/8 (H) x 15 (D) in.)
[When using the support columns L]
9.5 kg (20.16 lbs)
577 (22-3/4)
4
Referring to steps 2 and 3 in Attaching the
Plasma Display (Page 17.), remove the
black screws (4 screws).
Note
Do not remove the silver screws. If you do, the column
supports might slip out of place and fall over.
5
Holding the plasma display by its handles
and from the bottom, lift the display verti-
cally.
6
Place the plasma display slowly onto the
sheet laid out in step 2 with its screen
facing downwards.
Note
When reattaching the plasma display to the stand, be
certain that the left/right support columns are set at the
same angle.
1
2
1
2
93 (3-11/16)
23 (15/16)
125
162 (6-7/16)
380 (15)