Fixing The Rotation To The Front; Detaching The Pioneer Television From The Stand; Specifications - Pioneer KURO PDK-TS36B Bedienungsanleitung

Fixing the rotation to the front

Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Use a screw that has a nominal
diameter of M4 and length
from 0 mm to 30 mm (13/16 to
1-3/16 inch) to fix the rotation
to the front.

Detaching the Pioneer Television from the Stand

To remove the Pioneer television from the
stand, be sure to always follow the procedure
described below to prevent accidents.
1
First, confirm that the forward/backward
inclination anchor bolt is securely
tightened.
2
First clear a space on a flat floor etc.
where you can lay the Pioneer television
flat, then lay a sheet to protect it from
scratches or other damage.
3
Remove the speakers.

Specifications

External dimensions
Weight
• The above specifications and exterior may be modified without prior notice to improve the product.
10
En
577 mm (W) x 321 mm (H) x 380 mm (D) (22-23/32 in. (W) x 12-5/8 in.(H) x 14-31/32 in. (D))
[When using the support columns S]
10.8 kg (23.9 lbs)
4
Referring to steps  and 3 in "Attaching
the Pioneer Television" (Page 5.), remove
the installation screws (4 screws).
Do not remove the screws (M8 x 16 mm: silver) by
procedure  in Page 5. The support columns might slip out
of place and fall over.
5
Holding the Pioneer television by its
handles and from the bottom, lift the
display vertically.
6
Place the Pioneer television slowly onto
the sheet laid out in step  with its screen
facing downwards.
When reattaching the Pioneer television to the stand, be
certain that the left/right support columns are set at the
same angle.