Programming The Clearray (Ultraviolet) Water Purification System - Sundance Spas 680 Serie Benutzerhandbuch

680 EXPORT SERIES
L3 Lock Mode (disables the temperature up and down buttons to
prevent unauthorized temperature adjustments). Filtration/heating
cycle will continue to operate as programmed in this mode. The
jets and lights buttons will still continue to operate as normal. The
temperature display flashes when this function is enabled.
Note: To exit a Lock Mode you will need to re-enter the filtration/heating
modes and select a cycle from F1-F6.
10.6 Programming the CLEARRAY (Ultraviolet) Water Purification
System
A. Programming the CLEARRAY System (U) or Corona Discharge
Ozone (O3)
Press and hold the Jets pump 1 (
same time for 3 seconds to enter the sanitizing system program. The
screen will display one of the two menus below:
CLEARRAY menu
1. If the LED screen is displaying "U" then pressing the Jets pump
1 will change the sanitizing system from "U" to "O3" and exit the
programming menu. If the LED screen is displaying "O3" then
pressing the Jets pump 1 will change the sanitizing system from "O3"
to "U" and exit the programming menu.
Note: For the O3 option the "=" disables the duration countdown timer.
2. If you do not wish to change the option do not press any buttons and
after 10 seconds the display will return to the main menu.
Note: If the CLEARRAY System has been selected, when the
time allotted has expired (365 days) the display screen will
flash between the water temperature and "blb." At this time the UV bulb
must be replaced, the quartz tube must be cleaned and the duration
countdown timer needs to be reset.
Page 32
Press
or
) and Cooler (
O3 menu
Press
or
) button at the