Victron energy BMV-600S Anleitung Seite 18

R DEF: Reset to factory defaults. Reset all settings to the factory defaults by
holding the select button for 5 seconds.
Cl HIS: Clear historic data. Clear all historical data by holding the select
button for 5 seconds.
Lock: Setup lock. When on, all settings (except this one) are locked and
cannot be altered.
SW: Firmware version (cannot be altered).
BMV-602S ONLY
AlS: Alarm low starter battery voltage. When the starter battery voltage
falls below this value for more than 10 seconds the low starter
battery voltage alarm is turned on.
AlSc: Clear low starter battery voltage alarm. When the starter battery
voltage rises above this value, the alarm is turned off. This value
needs to be greater than or equal to AlS.
AhS: Alarm high starter battery voltage. When the starter battery voltage
rises above this value for more than 10 seconds the high starter
battery voltage alarm is turned on.
AhSc: Clear high starter battery voltage alarm. When the starter battery
voltage falls below this value, the alarm is turned off. This value
needs to be less than or equal to AhS.
RlS: Relay low starter battery voltage. When the starter battery voltage
falls below this value for more than 10 seconds the relay will be
activated.
RlSc: Clear relay low starter battery voltage. When the starter battery
voltage rises above this value, the relay will be de-activated. This
value needs to be greater than or equal to RlS.
RhS: Relay high starter battery voltage. When the starter battery voltage
rises above this value for more than 10 seconds the relay will be
activated.
RhSc: Clear relay high starter battery voltage. When the starter battery
voltage falls below this value, the relay will be de-activated. This
value needs to be less than or equal to RhS.
D VS: Starter battery voltage display. Determines if the starter battery
voltage is available in the monitoring menu.
14