Orascoptic XV1 series Gebrauchsanweisung Seite 9

Operating Your XV1 Series
Set Up the XV1 Series for Use
The batteries are partially charged when shipped. They should be fully
charged prior to use. Follow instructions in the Battery Charger section.
1. Insert a fully charged battery into each battery pod (Figure 6).
The metal contacts of the battery should be visible in the
battery pod opening.
2. With the batteries inside, screw each battery pod clockwise
onto the temple arms. Do not over-tighten the battery pods.
Point the headlight away from your eyes
because the light beam is strong.
Operate the Headlight
The XV1 series uses capacitive touch controls, making the light simple
to operate during clinical procedures.
1. Touch and hold the emblem on either temple arm to turn the
headlight on and off (Figure 7-1).
2. Tap the emblem on either temple arm to alternate the light
intensity between low and high. The XV1 series remembers your
light intensity setting when turned off, and it will automatically
return to that setting when used again.
3. Rotate the headlight and yoke up or down to align the light
with your field of view (Figure 7-2).
Battery Indicator Lights
Each temple arm has a low-battery indicator light that illuminates scarlet
when the corresponding battery is ready to be recharged (Figure 8-1).
The XV1 series automatically draws power from the second battery
when the capacity of the first battery is depleted. The indicator light
will flash when the headlight is turned off and will remain constant
when the headlight is turned on.
10
INSTRUCTIONS FOR USE
!
CAUTION
Orascoptic XV1 Series
7-1
7-2
8-1
Figure 6
Figure 7
Figure 8