Inhaltsverzeichnis
Werbung
C
D
E
1
2
1
2
MODE / PAUSE
3
FILE
5
REC / STOP
R03 (AAA) × 2
4
REC
5
3
PREPARATION
HOLD switch b C
Release the HOLD switch before operation to activate the buttons. b a
When not using the unit, set the HOLD switch to HOLD position. b b
Accidentally pressed buttons will not function.
If a button is pressed when the HOLD switch is set to the HOLD position,
"hold" flashes in the display.
Turning on and off
Press REC/STOP, c/sPLAY/STOP, MODE/PAUSE or FILE to turn on the
power. When c/sPLAY/STOP is pressed, the power is turned on and
playback starts.
If no new operations are done within 1 minute from the last operation, the
power is turned off automatically (Auto Power off function).
To attach the hand strap b D
To clean the cabinet
Use a soft cloth lightly moistened with a mild detergent solution.
Do not use strong solvents such as alcohol, benzine or cleaner.
RECORDING FROM THE BUILT-IN MICROPHONE b E
This unit has 4 recording files (A, B, C and D). You can record in 100
recording tracks on each recording file.
1 Release the HOLD switch.
2 Press MODE/PAUSE repeatedly to select a recording mode.
SP:
You can record for up to about 56 minutes.
LP:
You can record for up to about 120 minutes.
V-SP
: You can record for up to about 56 minutes with the V-SENSOR
k
function.
V-LP
: You can record for up to about 120 minutes with the V-SENSOR
k
function.
Select SP to record the sound more clearly.
About the V-SENSOR function, please refer to "V-SENSOR function"
below.
3 Press FILE repeatedly to select a recording file.
4 Orient the built-in microphone to the sound source.
5 Keep REC/STOP pressed for 1 second.
The REC indicator lights up in red, then recording starts.
a Recording track number
b Recording indicator
c Recording mode
d V-SENSOR indicator
e Elapsed recording time
Basic operation
To stop recording
Press REC/STOP or c/sPLAY/STOP.
To pause recording
Press MODE/PAUSE.
To resume, press MODE/PAUSE, REC/STOP or
c/sPLAY/STOP.
Note
You cannot change the recording file during recording.
To see the remaining recording time
Press FILE during recording or while in recording pause mode. The
remaining recording time is displayed while the button is pressed.
• The remaining recording time is approximate values.
When FULL is displayed
You cannot record any more. Erase unnecessary recordings.
V-SENSOR function
If you select V-LP
or V-SP
in step 2, the recording starts when the unit
k
k
detects sound above a preset level. If the unit does not detect the sound for
about 2 seconds, recording will pause and "SEnS" flashes.
This function prevents memory waste and empty recording.
Note
• The sensor level is factory-preset and you cannot change the level. Before
using the V-SENSOR function, please be sure to record once to confirm
the sensor level.
• When recording resumes after sound detection, the very first sounds may
not be recorded.
Werbung
Inhaltsverzeichnis
