Esata Connection - Akasa integral P2NSX Bedienungsanleitung

eSATA CONNECTION

NOTE:
Motherboard or adapter card with eSATA interface is required.
Connecting the Integral SATA (eSATA mode)
1. Make sure the system is switched off.
2. Connect both Type A connectors of the USB-to-DC cable to any two available USB ports on
the PC / MAC.
3. Connect the other end of the USB-to-DC cable into the DC 5V port of your Integral SATA enclosure.
The LED integral logo should light on.
4. Use supplied eSATA cable to connect the INTEGRAL drive to the motherboard's eSATA external port. If
the port is not present you may need to install an eSATA adapter (eSATA-45-EX).
eSATA Connection
8