TFA 35.1084.IT Betriebsanleitung Seite 41

up. This code must be received and stored by the weather station in the first 3 minutes of power
being supplied to the transmitter.
SETTING UP:
Note: This weather station receives only one outdoor transmitter.
First, insert the batteries into the Temperature transmitter. (see "Install and replace
1.
batteries in the temperature transmitter").
2. Immediately after and within 30 seconds, insert the batteries into weather station (see
"Install and replace batteries in the weather station"). Once the batteries are in place, all
segments of the LCD will light up briefly. Following the time as 0:00 and the "Weather boy"
icon will be displayed. If these are not displayed after 60 seconds, remove the batteries and
wait for at least 10 seconds before reinserting them.
3. After inserting the batteries, the weather station will start receiving data from the transmitter.
The outdoor temperature and the signal reception icon should then be displayed on the
weather station. If this does not happen after 3 minutes, the batteries will need to be
removed from both units and reset from step 1.
4. In order to ensure sufficient 868 MHz transmission however, this should under good
conditions be a distance no more than 100 meters between the final position of the weather
station and the transmitter (see notes on "Mounting" and "868 MHz Reception").
40