HAIRCUT TH33 Benutzerhandbuch Seite 27

5 Servicing
5.1 Blades
Use the soft brush supplied to remove hair from the blades. Never rinse the clippers
with water. If necessary, use a cloth slightly dampened with water or mild liquid
soap. Never use abrasive products or solvents. The blades can be cleaned with a
STERIL CLEANER 920- and 921- antibacterial spray. Use this cleaning product only.
In the case of regular use, clean the blades at least once a day.
Figure 8: Cleaning the cutters.
4. Use the cleaning brush (Figure 8, D) to remove hair from the gaps between the
fixed cutters (Figure 8, C) and the mobile cutters (Figure 8, A). Never remove
the cutters or their springs from the holder.
5. Apply 1 or 2 drops of lubricating oil on each of the 5 cutter lubrication points
(Figure 7).
6. Put the blades back on the clippers.
5.2 Charging contacts
The charging contacts on the clippers and the charging base must be kept clean at
all times. Otherwise, the clippers may not be charged correctly.
1. Detach the blades by pressing
on the spot shown by the arrow
(Figure 6) with your thumb.
2. Use the cleaning brush supplied
to clean the blades.
3. Push the plastic holder (Figure
8, B) back with your thumb to
separate
(Figure 8, C) and the mobile
cutters (Figure 8, A) by about
2 mm.
27
the fixed cutters