Fixing Anchors And Screws; Installing The Wall Mounting Supporter - LG OCF100 Benutzerhandbuch

4

Fixing Anchors and Screws

< Please follow the directions below >
y Check the material of the wall and thickness of finishing material.
y You can use the anchors and screws provided with the TV set for the wall made with concrete,
lightweight concrete, soft fieldstone, hard fieldstone, brick or cellular block.
y Do not mount on the wall made with plaster board or medium density fibreboard (MDF). Otherwise, you
must fix the anchor screws to the retaining wall (concrete) inside the finishing material. If there is no
retaining wall, you must install a separate hanger first to fix the anchors and screws.
y When installing the product on the wall that is not specified in this manual, make sure that each fixing
point withstands an pullout load of 70 kgf (686 N) and a shearing load of 100 kgf (980 N) or more.
1
4
y Use the Ø 8 mm drill bit for concrete wall and hammer (Impact) drill.
1 Use a Ø 8 mm drill bit to make a hole with a depth of 80-100 mm on the anchor position.
2 Clean the drilled holes.
3 Insert the provided anchor in the hole. (Use a hammer when inserting the anchor.)
4 Place the angle adjusting part to face upward. Place the angle adjusting part to face upward.
5 Align the wall mounting screws with the holes to tighten the screws. Tighten the screw using a
recommended torque of 45 kgf/cm - 60 kgf/cm or more.

Installing the Wall Mounting Supporter

5
<How to tighten the screws>
y Tighten the four wall mounting screws.
y If the screws cannot be fixed in the
designated location, move the bracket to
the left or right to fix the screws.
y Fix the wall mounting supporter using the
wall mounting screws as shown in the
figure.
y Tighten the screws until the wall, the wall
mounting supporter and the screws are
joined together securely using a (manual
or electric) Phillips screwdriver or 8 mm
spanner.
2
5
Wall mounting screw
INSTALLATION
Anchor
3
Wall Mounting Screw
9