Philips AZ 2755 Bedienungsanleitung Seite 11

GENERAL INFORMATION ON RECORDING
• Recording is permissible insofar as copyright or other rights of
third parties are not infringed.
• Recording is only possible on deck 1.
• This deck is not suitable for recording on CHROME (IEC II) or
METAL (IEC IV) type cassettes. For recording, use NORMAL
type cassettes (IEC I) on which the tabs have not been broken.
• The best recording level is set automatically. Altering the
VOLUME and DBB controls will not affect the recording in
progress.
• At the very beginning and end of the tape, no recording will
take place during the 7 seconds, when the leader tape passes
the recorder heads.
• To protect a tape from accidental erasure, have the tape in
front of you and break out the left tab.
Recording on this side is no longer possible. To record over this
side again, cover the tabs with a piece of adhesive tape.
Dubbing: Copying from deck 2 to 1
For best results, use mains power or fresh batteries.
1. Press TAPE source button.
2. Press both STOP•EJECT 9/ keys and insert a recorded tape
into deck 2 and a suitable tape for recording in deck 1.
3. Press PAUSE ; on deck 1 and then RECORD 0.
4. To start dubbing, press PLAY 2 on deck 2. PAUSE ; on
deck 1 is then released.
– By pressing PAUSE ; on deck 1, you can omit undesired
passages while deck 2 continues. Press deck 1 PAUSE ; to
resume dubbing.
– Pressing PAUSE ; on deck 2 will create pauses.
5. To stop recording, press both STOP•EJECT 9/ keys.
RECORDING
CD
TU NE R
TA PE
PR OG
ST OP
SE AR CH
PL AY /PA US E
BA N
11