Wall Mounting - Sharp HT-SB95 Bedienungsanleitung

6
Remote control battery replacement
2
1
3
4
The remote control requires a CR2025, 3V Lithium battery.
1. Push the tab on the side of the battery tray towards the tray.
2. Now slide the battery tray out of the remote control.
3. Remove the old battery. Place a new CR2025 battery into the
battery tray with the correct polarity (+/-) as indicated.
4. Slide the battery tray back into the slot in the remote control.
Placement and Mounting
A B
A: Normal Placement (place Soundbar on leveled surface in front of
TV)
B: Wall Mounting

Wall Mounting

NOTE:
ū Installation must be carried out by qualified personnel only.
Incorrect assembly can result in severe personal injury and property
damage (if you intend to install this product yourself, you must
check for installations such as electrical wiring and plumbing that
may be buried inside the wall). It is the installer's responsibility to
verify that the wall will safely support the total load of the unit and
wall brackets.
ū Additional tools (not included) are required for the installation.
ū Do not overtighten screws.
ū Keep this instruction manual for future reference.
ū Use an electronic stud finder to check the wall type before drilling
and mounting.
1
708 mm
1
708 mm
2
3
2
4
708 mm
708 mm
3
3
2~3mm
2~3mm
1. Drill 4 parallel holes (Ø 5.5~6 mm each according to wall type) in
the wall. The distance between the holes should be 708 mm.
Firmly fix 1 dowel into each hole in the wall if necessary.
2. Tighten the wall mount brackets on the wall with screws and
screwdriver (not included). Make sure the they are securely
installed.
3. Loosen the screws at the back of the unit for 2~3 mm.
4. Lift the unit onto the wall mount brackets and slot into place.
Connections
HDMI ARC input
The ARC (Audio Return Channel) function allows you to send audio
from your ARC- compliant TV to your sound bar through a single HDMI
connection. To enjoy the ARC function, please ensure your TV is both
HDMI-CEC and ARC compliant and set up accordingly. When correctly
set up, you can use your TV remote control to adjust the volume
output (VOL +/- and MUTE) of the sound bar.
ū Connect the HDMI cable (not included) from unit's HDMI (ARC)
socket to the HDMI (ARC) socket on your ARC compliant TV. Then
press the remote control to select HDMI ARC.
TIPS:
• Your TV must support the HDMI-CEC and ARC function. HDMI-CEC
and ARC must be set to On.
• The setting method of HDMI-CEC and ARC may differ depending
on the TV. For details about ARC function, please refer to your TV
owner's manual.
• Only HDMI cables of version 1.4 or higher can support the ARC
function.
Ø5.5~6mm
32mm
Ø5.5~6mm
32mm
4
4