Polaris 180 Bedienungsanleitung Seite 8

Troubleshooting
If the Polaris cleaner displays the following
actions, a djustments m ay b e n ecessary t o r estore
performance. R efer t o e xploded p arts d iagram f or
part references.
Action:
Solution: 1. C heck the wheel RPM.
Action:
Solution: 1. C heck t he f ilter s creen i n t he Q uick
Action:
Solution: 1. C onfirm that the blue restrictor
H angs up on steps or other
obstacles for longer than 3
minutes.
2. V erify the back-up valve
is cycling.
3. A djust the thrust jet.
4. R emove unnecessary pool
hardware o r i nstall a L adder G uard
Kit ( order p art # G21 f rom a P olaris
dealer).
P olaris is sluggish, running
with less power than normal.
Disconnect a nd c lean, i f n ecessary.
2. C lean t he s kimmer b asket, p ump
basket, and pool filter.
3. C heck a ll o f t he h oses, c onnections,
and swivels for leaks that could
cause loss of water pressure.
4. C heck the wheel RPM.
Polaris flies around the pool
and/or does not make contact
with the bottom.
disk is installed in the UWF to
decrease water flow. Or, install
the r ed r estrictor d isk t o d ecrease
water flow even more.
2. Check the wheel RPM. If more
than 32 RPM, unscrew the
pressure relief valve to decrease
water flow
to cleaner. Note: The pressure
relief valve should only be
adjusted when a restrictor is
installed.
3. V erify t he b ack-up v alve i s c ycling.
Hold t he v alve o ut o f t he w ater a nd
watch the jet. It should come on
and go off.
www.polarispool.com
Action: Polaris does not back up.
Solution: 1. V erify the back-up valve
is cycling.
2. C heck the wheel RPM.
3. I f the bag is full, empty it.
4. If head float has water in it,
replace it.
5. M ake sure feed hose is floating.
Action: Polaris only turns in one
direction.
Solution: 1. A djust the thrust jet.
2. M ake sure feed hose is floating.
Action: F eed hose becomes tangled.
Solution: 1. R emeasure t he h ose t o v erify t hat
it i s a djusted t o t he p roper l ength
for the pool shape.
2. W ith t he P olaris o perating, c heck
that the swivels in the hose and
the h ose c onnections t urn f reely.
3. M ake sure feed hose is floating.
4. W ith the Polaris turned off, spin
each of the wheels. All wheels
should turn together.
Action: S weep hose is sucked into
the vacuum tube.
Solution: 1. M ake s ure t he o pening a t t he e nd
of t he s weep h ose i s n ot b locked
by the sweep hose scrubber.
2. A djust t he s weep h ose t o a g entle
sweeping motion.