I N St Allin G A Nd Connecting - NAIM NAIMUNITI Kurzanleitung

NaimUniti Quick Start Guide

1 I n st allin g a nd Connecting

• Unscrew and remove the CD drawer transit bolt from the underside of the unit.
Handle NaimUniti with extra care once the bolt is removed. Retain the bolt for future
use. Stand NaimUniti on an appropriate, stable surface. Make sure NaimUniti is well
ventilated.
power switch
mains input
and fuse
• Check that the mains
your territory. Connect NaimUniti to the mains using the supplied cable but do not
switch it on until all other connections have been made.
• Identify the Signal ground Switch
connected in a hi-fi system incorporating another earthed source component, or
mains "hum" is audible through the loudspeakers when NaimUniti is switched on.
• Connect the left and right speakers to the
when connecting speakers that the positive and negative connection orientation at
both ends of the cable is the same for both channels.
daB/Fm
• If the NaimUniti
DAB/FM aerial socket. The DAB/FM tuner cannot operate without an aerial. Contact
your local Naim retailer or distributor for advice on selecting and installing an aerial.
subwoofer
• If a is to be used, connect its signal cable to one of the subwoofer outputs
on the NaimUniti rear panel. The NaimUniti subwoofer outputs must be enabled and
configured from the Speakers setup menu. Press the handset
Speakers. See the Reference Manual for more information.
• If any external audio sources are to be used with NaimUniti, connect these, using
the appropriate cables, to the rear panel
preamplifier is to be used, connect it using the cable supplied with the preamplifier, to
phono
the input.
• If NaimUniti is to play audio from a UPnP™ server or from an internet radio station
either its network socket
or its WiFi antenna must be fitted.
connection.
Note:
NaimUniti is configured when shipped to connect to a wired network automatically.
However, if your NaimUniti has been previously used and its network configuration altered,
or your router requires non-standard settings, it may not be able to do so. Refer to the
Reference Manual or contact your retailer if this appears to be the case. If a wireless
network connection is to be used, it is likely that configuration will be required via a setup
menu. Refer to the Reference Manual for more information.
Full naimuniti installation and operational information can be found in the reference manual
left right
speaker speaker
supply specified on the NaimUniti rear panel is appropriate for
and select the "chassis" option unless NaimUniti is
speaker outputs
tuner is to be used, a suitable aerial must be connected to the
analogue
must be connected to a router using an RJ45 Ethernet cable
iradio also requires a high-speed network internet
available on line at www.naimaudio.com
wireless network (WiFi) network
antenna socket socket
signal ground switch subwoofer
outputs
on the rear panel. Ensure
setup
( ) key and select
or digital inputs. If a Naim
English
iPod input
analogue
phono
inputs
input
Speakers
Large + Sub
4Type:
Max. Volume:
Balance:
phono
DAB/FM aerial
socket
digital
inputs
1/3
100
0