Silvercrest SWV 300 C1 Bedienungs- Und Sicherheitshinweise Seite 198

SilverCrest SWV 300 C1
There are two different ways to configure the wifi range extender.
If you are not using the network default settings on your computer and have manually
set an IP address, you must restore the network settings to Automatically obtain
an IP address. For further details, please read the operating instructions for your
computer.
1. You can then configure the wifi range extender via the network cable. If you want to configure the
wifi range extender via the network cable, you must connect the wifi range extender to your
computer. Use the network cable included with the device for this purpose. Insert one end of the
network cable into the WAN/LAN socket (6) or the LAN socket (7) of the wifi range extender and
the other end into the LAN socket of your computer.
2. Alternatively, you can perform the configuration via a wireless network. To do so, start the search
for available wireless networks on your computer. The network SWV 300 C1 is displayed in the
list of available wireless networks. Select the network SWV 300 C1 and click on the Connect
button to connect wirelessly to the wifi range extender. After having pressed the Connect button,
you may have to click the option Connect without configuring the network.
Open the Internet browser on your computer. Enter http://repeater.setup in the address line of the
Internet browser and confirm the entry with the Enter button.
196 - English