OBO Bettermann ISSMKS Montageanleitung Seite 32

Information on the product
No . Product name
Side panelling
5
Device panel door
6
Cable outlet
7
Floor screen
8
Hinge
9
Counter-bearing
10
Fastening
strap
11
Door stop
12
Door supports
13
Device panel
14
interior
Device panel
15
exterior
Bolt lock
16
Small distributor
fastening plate
17
Small distributor
18
Wiring
trunking
19
32 | EN
Figure Function
The side panelling covers the outer sides of the media
pole.
The device panel door is used to accept different sockets
and multimedia/data technology connections. The door
protects the inner device panel against access.
Cables to be inserted in the device panel are run into the
media pole through the cable outlet.
The floor screen covers the lower part of the media pole.
The hinges are installed in both doors and can be unlo-
cked using a cylinder lock, meaning that the doors can be
dismantled. The side of the door hinges can be changed
over at a later date.
The counter-bearing is used to accept the doors and as a
counter-bearing for the hinges.
The fastening strap is used to fasten the media pole on
the wall. The height of the straps can be moved variably.
The door stop serves as a bearing point for the door.
The lock bolt engages behind the door support.
Here, a cavity wall socket can be used to mount sockets
and multimedia/data technology connections.
Here, a cavity wall socket can be used to mount sockets
and multimedia/data technology connections.
The bolt lock locks the door and is used to accept a
profiled half cylinder.
The small distributors are fastened to the media pole using
the small distributor fastening plate.
Small distributor panel with 2 low-voltage distributors
(2x 36 PUs).
The cables of the devices can be wired and connected via
the wiring trunking.
OBO Bettermann