Werbung
UK SPECIFICATIONS OF USE FOR YOUR BREVA
A
HOW TO USE THE INTERNAL SUN VISOR ON YOUR HELMET
The control button for the internal sun visor is located on the left hand side of the helmet. Only use this
•
button when you are stationary and always use your left hand.
To lower the internal sun visor, push the control button forward until it stops (A).
•
To raise the internal sun visor, push the control button backward until it stops (B).
•
Warning: never drive with the internal sun visor in the lowered position at night or in case of poor visibility.
Always remember to raise the internal sun visor early enough before entering a tunnel or on a dark or
shady road.
HOW TO CHANGE THE INTERNAL SUN VISOR ON YOUR HELMET
The main visor must be in the open position.
•
The internal sun visor must be in the lowered position (C).
•
Hold the internal sun visor between 2 fingers and pull it gently toward the back until the 2 clips situated
•
on the internal sun visor detach from the 2 lugs situated inside the mechanism (D).
To replace the visor:
Hold the main visor in the open position
•
The button must be in the backward position until it stops (E).
•
Slide the visor back as far as it will go, until you hear a double click, indicating it is clipped correctly on
•
the lugs (F).
Ensure the mechanism is working properly by moving the control button from the front to the back and
•
from the back to the front.
The internal visor is available in 2 versions: tinted 80% (original version), and amber high visibility.
•
I
B
C
J
K
CLIC
D
E
HOW TO REMOVE AND PUT CHEEK PADS BACK ON YOUR HELMET
Take the front part of the cheek pad with your fingers and, moving from top to bottom, pull it lightly
•
toward the inside of the helmet (G).
Gently detach the pad from its housing in the polystyrene by making small
•
motions in order not to break it (H).
Detach the pad from the strap.
•
To put the pad back on:
Insert the strap through the pad first (I).
•
Insert the slim part of the pad in its housing between and under the shell (J).
•
While exerting pressure with slight motions from top to bottom, place the pad
•
in its original housing (K).
Then pull the strap to check that it is in order.
•
HOW TO REMOVE AND PUT THE HEAD PAD BACK ON YOUR HELMET
First, remove the sun visor (see previous procedure).
•
The head pad is maintained in position on the front by the strip inserted in 3 clips.
•
Pull lightly on the left or right hand side of the front part, toward the interior with regard
•
to the edge of the helmet. By doing so you are detaching the front fixing strip (L).
Next, pull lightly on the small red strap situated on the rear part, towards the interior
•
from the edge of the helmet. You are now detaching the rear fixing strip (M).
Remove the entire pad from the helmet.
•
To put the head pad back on:
Insert and fix the rear strip first between the nape and the edge of the polystyrene (N).
•
Insert the front strip making sure that it is set properly between the 3 fixing clips (O).
•
The head pad sets itself easily on its own.
•
L
M
CLIC
F
G
N
O
H
Werbung
