NAMCO 500 GP Dlxe Handbuch Seite 55

4. Remove the 2off hex head screws (M5x35) and remove the cover strip.
5. Remove 20ff hex head screws (M5x35), unlock and remove the back door.
6. Remove 2off hex head screws (M10x130), spring and square flat washers.
7. Lift the monitor approx. 10cm from the monitor base and then move it forwards
or backwards clear of the monitor base.
Note: When placing the monitor on the floor or replacing on to the monitor base,
take care not to trap hands or fingers.
Cover strip
Hex head screw
(M5x35)
Back door
Lock
Spring washer
Hex head screw
(M10x130)
Page 55
Square flat washer