Aiwa AM-F75 Bedienungsanleitung Seite 16

5
1
1
2
3
4
16
PREPARATIONS
2,4
3,4 Setting the clock
• If you set the clock before use, the date
will be recorded automatically every time
a recording is done.
• Before setting the clock, make sure that
enough battery power remains.
Operate when the power is off.
1 Keep DISP pressed for about 3
seconds.
"CLOCKSET" is displayed.
2 Turn MULTI JOG to set the year.
3 Press h.
The month starts flashing.
4 Repeat the steps 2 and 3 to set the
month, day, hour and minute.
5 Press ENTER.
The clock starts from the 00 seconds.
To correct a setting mistake
Press h repeatedly until the digits to be
corrected are flashing, then turn MULTI
JOG to reset them.
To see the time
Press DISP while in the stop mode.
Press again to see the date.
Note
The clock does not work properly in the
following cases:
• when the unit is not used for a long period
of time
• when the batteries are removed for a long
period of time
In these cases, you cannot see the time
even if you press DISP.
Set the clock again.
About the built-in back-up battery
The built-in back-up battery retains the time
and date when the batteries are removed.
When the back-up time becomes extremely
short, consult your nearest Aiwa service
personnel to change the back-up battery.
English