Merida M44A Montage- Und Benutzerhandbuch Seite 4

BREAKDOWN LIST OF BASIC PARTS
Cover
Motor + Fan Wheel assembly
Heating element
Electronic circuit set
Coal brushes set
PREVENTATIVE MAINTENANCE AND CLEANING
Correct cleaning of the machine will lengthen its working life considerably.
When in use, the machine will accumulate dust inside which should be cleaned out if used regularly,
at least twice a year.
It is recommended to carry out the cleaning of the appliance as a minimum once a year, following the next
recommendations:
1. Disconnect the electrical supply to the dryer.
2. Extract the cover of the appliance after having undone both the two lower screws.
3. With a brush with soft bristles, take away the dust accumulated into the structure of the appliance (base)
and in the inner side of the cover.
4. Brush the aspiration area (upper central hole) and take away the dust deposited on the fan wheel.
5. Carefully remove the dust accumulated in the electronic circuit with the help of a thin brush. Make sure
that no dust or residual dirt is left in the detection sensors.
6. Try that the screen of the IR LEDs (lower cover window) is clean and make sure of its transparency.
7. Restore the cover once again and switch on the appliance.
8. Run several times the dryer in order to force out the remaining dust.
NOTE: The whole maintenance and cleaning process must be carried out by authorized technical personnel.
IN CASE OF NOT ALOWING THOSE RULES YOU MAY LOOSE YOUR WARRANTY.
4
1a Code RC96205-MER
1b Code RC96205-BW
2 Code RC96748-MER
3 Code RC96237-MER
4 Code RC96600-MER
Code RC96750-B-MER
5
Code RC96750-J-MER
1a
2
5
3
1b
4
GB