Wiring Diagram - Merida M44A Montage- Und Benutzerhandbuch

INSTALLATION
Terminal strip location and Ø22 mm cables access hole
NOTE: Please plan for a minimum distance of 40 cm (15.75") in relation to possible shelfs, marble surfacesor
washing basins. Avoid as much as possible the presence of reflecting surfaces in the area of actuation of the
appliance IR sensors.
Machine must be manipulated only by an autorized technician.
ATTENTION: Whilst removing the cover, electrical live parts of the appliance are accesible.
During the installation process, the protection areas should be considered according to norm VDE 0100. The
hand dryer must only be installed on a closed surface (wall, partition or similar)

WIRING DIAGRAM

ELECTRIC DIAGRAM
N L
M – Motor
H – Heating element
S – Sensor
N L
M
H
S
Terminal strip
Hole
D > 4 0 cm ( 1 5 ,8 " )
Minimum distance shelfs
CONNECTION TO ELECTRONIC CARD
1 – Motor
2 – Heating element
3 –Input voltage cables
www.merida.eu
GB
1
1
2
2
3
22 0 - 24 0 V
5 0 /6 0 Hz
3