Specifications - THOMSON RK200CD Handbuch

SPECIFICATIONS

CASSETTE SECTION
Track format:
Recording system:
Erasing system:
Tape speed:
F.F. & REW time:
Frequency response:
CD SECTION
Channels:
S / N ratio:
Wow & Flutter:
Sampling frequency:
Quantization:
Pick up light source:
Pick up wave length
RADIO SECTION
Tuning ranges:
Antennas:
GENERAL
Output power:
Power consumption:
Aux In Jack:
Speaker:
Power source:
Dimensions:
Weight
Due to continuing improvement, the features and the design are subject to change without notice.
Where to place the item :
Today's furniture is coated with a wide variety of lacquers and synthetic-coatings that are treated with an
extensive range of cleaning products. Therefore, the possibility that some of these substances contain
components that react adversely to the rubber feet of the item and soften them, cannot be completely
excluded. The rubber feet of the appliance can cause discoloring to furniture surfaces. If necessary,
place the appliance on a non-slide surface.
Remark: In order to save energy when the unit has no sound output for a while, the unit will be
switched to stand-by automatically. It can be switched ON by using the function selector again.
Don't discard the electrical and electronic appliances in the regular waste disposal.
• Take them to a collection point.
• Some components in these appliances may be hazardous to health
and the environment.
2 track stereo
AC bias
Magnetic erase 6 poles
4.75 cm / sec.
170 sec. (F-60 tapes)
125 Hz - 8000 Hz (Normal tape)
2 channels
60 dB
undetectable
44.1 kHz 8 x over sampling
1 bit DA converter
Semi - conductor laser
790 nm
FM 87.5 - 108 MHz
AM 522 - 1620 kHz
AM Built - in ferrite bar
FM Rod antenna
1.2 W + 1.2 W (RMS)
9.5 W
3.5 MM
3 " 8 OHM
AC : 230V ~ 50Hz
DC : 9V ( 6 x 1.5V LR14/ "C"/UM2 )
294(L) x 206(D) x 153(H)mm
1.72 KGS
GB-9