Graphic Interface - elobau 485EPF series Originalbetriebsanleitung

Graphic interface

è
Module configuration must be
performed with the system switched
off (outputs OFF).
You can query the module configuration at
any time while the module is in use. To
configure the 485EPFx module, proceed as
follows:
1. connect the module to the
24VDC+20% power supply via the
terminal block;
2. connect the USB cable to the PC
and to the 485EPFx (or 485EPFUB)
module;
3. click on the "BUS
CONFIGURATOR – USER
INTERFACE" desktop icon.
The configuration window shown at the side
is displayed (Figure 7).
4. Press the "CONNECT" key.
The program recognizes that a bus module
is connected (Figure 8); the field bus model,
the firmware version and the Master
485EPB status are displayed:
green=485EPB active (RUN);
•
red=485EPB not active
•
(e.g. communication with the
configuration software).
eloProg 485EPF.. - Vers. 1.2
485EPB
Status
Figure 7
485EPB
Status
Figure 8
15