Led Mode - elobau 485EPF series Originalbetriebsanleitung

LED NET
STATUS INDICATION
On-line
GREEN
connected
GREEN On-line not
blinking (1Hz) connected
Critical
RED
connection error
RED blinking Time-out of 1 or
(1Hz) more connection
GREEN/RED
TEST
alternate

LED MODE

STATUS INDICATION
GREEN On-line
GREEN
On-line
blinking
RED
Parameterization
blinking
error
(1 flash)
RED
PROFIBUS
blinking
configuration error
(2 flashes)
STS LED
STATE INDICATION
OFF INIT
Green OPERATIONAL
Flashes PRE-
green OPERATIONAL
Flashes SAFE-
green once OPERATIONAL
Red (Fatal Event)
eloProg 485EPF.. - Vers. 1.2
MODULE 485EPFDN
DESCRIPTION STATUS
1 or more
connections GREEN
established
No connection GREEN
established blinking (1Hz)
485EPFDN unable
RED
to communicate
One or more I/O RED blinking
device in time-out (1Hz)
GREEN/RED
485EPFDN in Test
alternate
Table 7
MODULE 485EPFPD
DESCRIPTION STATUS
data exchange OFF
CLEAR GREEN
GREEN
rif. IEC 61158-6
blinking
configuration data
MASTER or MBP RED
wrong
Table 8
MODULE 485EPFEC
DESCRIPTION STATE
INIT or no power OFF
OPERATIONAL
Flashes red
state
PRE-
Flashes red
OPERATIONAL
twice
state
SAFE-
OPERATIONAL Red
state
System locked -
Table 9
LED STS
INDICATION
- Normal operation
Configuration incomplete, 485EPFDN
Pending
waiting for activation
One or more unrecoverable errors
Fatal error
detected
One or more recoverable errors
Error
detected
TEST 485EPFDN in Test
LED STS
INDICATION
MBP not
STATUS SETUP o NW_INIT
initialized
Initialized End of initialization NW_INIT
Initialized with
EXTENDED DIAGNOSTIC bit set
diagnostic active
Exception error EXCEPTION STATUS
ERR LED
INDICATION
No error No error or no power
Configuration not Status change requested by master not
valid possible
Watchdog
Synch manager watchdog timeout
timeout
Controller fault Anybus module in EXCEPTION state
- -
DESCRIPTION
DESCRIPTION
DESCRIPTION
9