Cleaning And Maintenance - LiveLine VDPLBTL Bedienungsanleitung

Custom Static Colour
You can create a custom colour by adjusting the intensity of the red (R), green (G), and blue (B) LEDs.
To use a custom static colour:
1. To adjust the red LEDs, press R and then press + or – to set the desired intensity.
2. To adjust the green LEDs, press G and then press + or – to set the desired intensity.
3. To adjust the blue LEDs, press B and then press + or – to set the desired intensity.
4. To activate the custom colour, press MANUAL.
Note: The A, UV, and W buttons have no function.
Automatic Program
To use an automatic program, proceed as follows:
1. Press AUTO and then press + or – to select the desired program (P1–P4).
2. To set the speed of the program, press SPEED and then press + or – to adjust.
Fading Colours
To use an automatic program with fading colours, proceed as follows:
1. Press FADE and then press + or – to select the desired program (P2 or P4).
Sound-Activated Program
To use a program with sound activation, proceed as follows:
1. Press SOUND and then press + or – to select the desired program (Snd1/Snd2).
2. To change the sensitivity of the internal microphone, press SENSITIVITY and then press + or – to
adjust.
Master Dimmer
To adjust the overall brightness of the light output, press % and then press + or – to set the desired
brightness.
Adding a Strobe Effect
To add a strobe effect, proceed as follows:
1. Press STROBE and then press + or – to set the desired strobe speed.
2. To switch off the strobe effect, press STROBE again.
Switching Off
To switch off all LEDs, press BLACKOUT. Press BLACKOUT again to switch on.
9. Charging Your Trussled 33B
The device can be powered through the internal lithium battery. To do so:
1. Make sure to set the on-off switch [8] to the off position.
2. Insert the power cord into the power input [2] and connect the device to the mains.
3. We recommend charging the device for at least 6 hours prior first use.
10.

Cleaning and Maintenance


All screws shall be tightened and free of corrosion.

The housing, the lenses, the mounting supports and the installation location (e.g. ceiling, suspension,
trussing) shall not be deformed, modified or tampered with; e.g. do not drill extra holes in mounting
supports, do not change the location of the connections...

Mechanically moving parts must not show any signs of wear and tear.

The electric power supply cables must not show any damage. Have a qualified technician maintain
the device.

Disconnect the device from the mains prior to maintenance activities. Let the device cool down.

Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.

Do not immerse the device in any liquid.

There are no user-serviceable parts, apart from the fuse.

Contact your dealer for spare parts if necessary.
VDPLBTL
www.liveline.be page 9