Operation With Remote Control; Inserting/Replacing The Battery; Using The Remote Control - LiveLine VDPLBTL Bedienungsanleitung

programmes
6
dimmer
7
dimmer speed
8
8.

Operation with Remote Control

Note: Make sure to unplug any connection from the DMX input of the device if you want to use it in
stand-alone mode. A device in stand-alone mode may transmit DMX signals that could interfere with the
DMX signals from the controller.
8.1

Inserting/Replacing the Battery

Warning! Do not puncture batteries or throw them in fire as they may explode. Do not
attempt to recharge non-rechargeable batteries (alkaline). Dispose of batteries in accordance
with local regulations. Keep batteries away from children.
To insert/replace the battery in the remote control, proceed as follows:
1. Press on the side of the battery holder [A] and pull [B] to slide it open.
2. Insert a new CR2025 lithium battery in accordance with the polarity markings on the remote
control.
3. Push the battery holder back into the remote until it snaps into place.
8.2 Enabling/Disabling the Remote Control
If you want to prevent (accidental) usage of the remote control, you can disable it via the menu. When
disabled, pressing the buttons on the remote control has no effect. Proceed as follows:
1. Press MENU until <SET> is displayed and press ENTER.
2. Use UP and DOWN to select <OFF> and press ENTER.
The remote control is now disabled.
3. To enable the use of the remote control again, select <On>.
8.3

Using the Remote Control

The remote control allows you to:

choose a static colour (built-in or custom)

choose an automatic program with speed adjustment

choose an automatic program with fading colours

run a sound-activated program with sensitivity adjustment

set the overall brightness of the light output (master dimmer)

add a strobe effect with adjustable speed

switch off all LEDs
Each function is described in detail below.
Built-in Static Colour
To use one of the built-in static colours, press one of the numbered buttons (0–9) on the remote control.
The button colour corresponds with the light colour.
VDPLBTL
000 031 no function
032 063 from 0 to 100 %
064 095 from 100 to 0 %
096 127 from 0 to 100 to 0 %
128 159 fading colours
160 191 3-colour change
192 223 7-colour change
224 255 sound control
000 255 from 0 to 100 %
000 051 preset dimmer speed
052 101 off
102 152 mode 1 (fast)
153 203 mode 2 (middle)
204 255 mode 3 (slow)
www.liveline.be page 8