Changing The Batteries; Calibration - Clearaudio Weight Watcher touch Bedienungsanleitung

User manual / Bedienungsanleitung

3. Changing the batteries

Weight Watcher touch
If the
be replaced.
To change the batteries, open the battery compartment by pressing the
lock and remove the cover. Pay attention to the polarity when inserting the
batteries. Now you can replace the cover.
Use caution and do not apply any pressure to the calibration /
measurement surfaces!

4. Calibration

If the measurements shown seem inconsistent use the supplied calibration
weight to recalibrate the
Weight Watcher touch
1. Place the
2. Hold down the 'MODE' button for approx. 3 seconds: the display will
show 'CAL' and then the required calibration weight.
3. Place the 100g weight (included) centered on the calibration area
(where the Clearaudio logo is shown) and wait 3 seconds.
4. Press 'ON/OFF'. The display
The calibration is completed.
Page / Seite 6
cannot be switched on, the batteries should
Weight Watcher touch
on a flat, stable surface.
.
© clearaudio electronic GmbH