Shutting Down The Compressor - MGF Ghibli 17 Gebrauchshandbuch

the factory to stop the motor when pressure in the receiver reaches its maximum, and
to start it again when the pressure in the receiver falls to the minimum preset value.
This operation is completely automatic and does not affect the spraying process in
any way. However, should problems develop with the cut-in, cut-out settings, please
consult your MGF dealer, or the MGF Service Department.
NOTE:
a. If the machine pumps continuously without cutting out then the compressor is too small for
the application/tool being used, and damage may result. Consult your MGF dealer.
b. The motor is protected by a Thermal Overload which will trip and stop the motor should it
overheat for any reason. Allow the motor to cool down for 15 – 20 minutes before
restarting.
c. Do not exceed the Duty Cycle for the machine (see Specifications).
1. Turn the ON/OFF switch (see A, Fig. 3-4) to the 'O' (OFF) position to switch the
compressor off.
2. Release air from the air hose before disconnecting the hose from the machine by turning
the air regulator knob fully anti-clockwise and triggering the spray nozzle.
3. Make sure all air is expelled from the receiver by opening the drain valve (F. Fig. 5) before
transporting your compressor or when leaving overnight.
DO NOT switch the compressor on or off at the mains. ALWAYS switch the compressor on or
MGF Silent compressors operating
instruction manual

SHUTTING DOWN THE COMPRESSOR

IMPORTANT:
off at the pressure switch ONLY.
F
Fig. 5
9