Inserting The Batteries Into The Remote; Connect Power; Important Safety Information; Antenna Connection - Teleco TEV20D Bedienungsanleitung

Scroll through the stored channels by pushing the
button up or down.
To change source: Press the middle of the button
twice(for the second time in total), the source list will
appear on the screen. Scroll through the available
sources by pushing the button up or down.
To turn the TV off: Press the middle of the button
down and hold it down for a few seconds, the TV will
turn into standby mode.
Notes:
• If you turn the TV off, this circle starts again
beginning with the volume setting.
• Main menu OSD cannot be displayed via control
button.
Operation with the Remote Control
Press the Menu button on your remote control to
display main menu screen. Use the directional buttons
to select a menu tab and press OK to enter. Use the
directional buttons again to select or set an item. Press
Return/Back or Menu button to quit a menu screen.
Input Selection
Once you have connected external systems to your
TV, you can switch to different input sources. Press the
Source button on your remote control consecutively
to select the different sources.
Changing Channels and Volume
You can change the channel and adjust the volume
by using the Volume +/- and Programme +/- buttons
on the remote.

Inserting the Batteries into the Remote

Remove the screw that secure the battery compartment
cover on the back side of the remote control first. Lift
the cover gently. Insert two AAA batteries. Make sure
the (+) and (-) signs match (observe correct polarity).
Place the cover back on. Then screw the cover back
on again.

Connect Power

IMPORTANT: The TV set is designed to operate on
12 V DC. For this, an adaptor is used which gives
12 V voltage. Connect this adaptor to a system that
supplies 110-240V AC, 50/60Hz.

Important safety information

Be sure to ground the connection
Connect the ground terminal of the AC
adaptor with the ground terminal provided
at the power outlet using the enclosed
power cord. If the provided plug does not
fit your outlet, consult an electrician for
replacement of the obsolete outlet.

Antenna Connection

Connect the aerial or cable TV plug to the AERIAL
INPUT (ANT) socket or satellite plug to the SATELLITE
INPUT (LNB) socket located on the back of the TV.
REAR
OF
THE TV

Notification

TRADEMARK ACKNOWLEDGMENT
The terms HDMI and High-Definition Multimedia
Interface, and the HDMI Logo are trademarks or
registered trademarks of HDMI Licensing LLC in the
United States and other countries.
English - 60 -
To POWER INPUT
DC 12 V terminal
AC adaptor
properly
Surely connect the ground wire.
satellite
aerial
or
cable