Electrical Connections - De Dietrich VM iSystem AD281 Installations- Und Wartungsanleitung

VM iSystem - AD281
2 Installation
2.1 Mounting
2.2

Electrical connections

11/10/2017 - 300027106-001-02
(0450281003)
The VM iSystem module can be affixed to the wall or in an electrical
cabinet.
1. Drill 3 holes.
(1) Drilling template
2. Affix the module.
3. Open the protective hood.
4. Secure the unit with the 3 screws.
( 1 )
CAUTION
4
4
C003570-C
2.2.1.
WARNING
4
4
4
Make the electrical connections of the appliance according to:
4 The instructions of the prevailing standards.
4 Belgium: Electrical connections must comply with the instructions
in the general regulations on electrical installations (RGIE).
4 Germany: Electrical connections must be in compliance with the
VDE0100 standard.
4 France: Electrical connections must be in compliance with the NF
C 15.100 standard.
4 Italy: Electrical connections must be in compliance with the CEI
standard.
4 The instructions on the electrical diagrams provided with the boiler.
Do not fit a power relay or a power circuit at a distance
of less than 10 cm from the box.
Failure to comply with these instructions could lead to
interference and control unit malfunctioning or even
damage to the electronic circuitry.
Recommendations
Only qualified professionnals may carry out electrical
connections, always with the power off.
The appliance is fully pre-wired. Do not modify the
connections inside the control panel.
Earth the appliance before making any electrical
connections.
2. Installation
EN
23